Dirt Is the greatest single cause of failure In hydraulic units. Keep the Jack clean and well lubricated to prevent foreign matter from entering the system. II the Jack has been exposed to rain, snow, sand, or grit, It must be cleaned before it is used. The use of alcohol, hydraulic brake fluid, detergent motor oil, or transmission oil could damage the seals and result in jack failure. Use only approved hydraulic fluid (type HL or HM) with an ISO grade cinematic viscosity of 30 cSt at 40° Coran Engler viscosity ol 3 at 50° C.
1. When the jack is not is use, keep the piston and pump rods fully retracted. Store the Jack on its base (in an upright position) and in a well protected area where it will not be exposed to corrosive vapors, abrasive dust, or any other harmful elements.
2. Visually inspect the jack before each use. Take corrective action if any of the following problems are found:
a. Cracked or damaged housing e. Incorrectly functioning swivel heads or adj. screw
b. Excessive wear, bending, or other damage f. Loose hardware
c. Leaking hydraulic fluid g. Modified or altered equipment d, Scored or damaged piston rod
Capacity from 4 to 75 Tn, stroke up to 40 mm.
Models with two and three stages.
Load return.
For use in confined spaces: machinery positioning, tool fastening.
Mounting bolt holes for easy fixing.
All models are black nitrided to improve corrosion and side load resistance
Capacity from 30 to 200 Tn, stroke up to 300 mm.
Spring return. Lock nut tested under 50% overload.
Mechanical end of stroke gland avoids over travel at full pressure.
Made out of high strength aluminium alloy.
All aluminium parts are treated to improve resistance and extend working life.
Lightweight. Over 40% weight reduction when compared with steel equivalent.
Fitted with steel base plate and saddle for wear resistance.
The lock nut holds the load mechanically for extended periods of time.
Not suitable for high cycle applications.
Products are blackodised for protection against rusting, for your specific requirement contact.
Product are produced from alloy steel and toughened to 25 to 35 HRC.
Special Seals are used to achieve required performance.
Product specifications are subject to change due to continuous technical improvement.
All components are processed to achieve desired performance.
Material of Construction
Cylinder - Alloy Steel
Piston - Alloy Steel
Other - Carbon Steel
Bout components - Standard make.
No information available.
© Copyright 2024 PRS Verse - All Rights Reserved.
Technology Partner - Exontric Systems
.svg)